Sensor Networks is pleased to announce our new clamps for microPIMS monitoring systems. The new clamps are either band or magnetic and compatible with Ultra-High-Temp and Corrosion Dual microPIMS. The simple installation process allows for increased speed and safety when installing corrosion monitors in hazardous environments. Here are the steps for installation:
Step 1 – Clean and smooth the surface
Step 2 – Place clamp around pipe
Step 3 – Tighten the T-Bolt
Step 4 – Remove the probe cap and slide on the top bracket. Replace the cap to secure the bracket.
Step 5 – Place a drop of glycerin on the face of the probe
Step 6 – Place couplant foil on the face of the probe
Step 7 – Carefully lower the probe face into the bracket hole. Apply pressure so the couplant foil is squeezed between the probe and the pipe surface.
Step 8 – Tighten down the hex head bolts
Success! – Correct tightness can be evaluated by the quality of the signal, thickness, and temperature reading. Additional tightening may be required.
